Unterschiede
Hier werden die Unterschiede zwischen zwei Versionen angezeigt.
Nächste Überarbeitung | Vorhergehende Überarbeitung |
projekte:cwloop:start [2022/03/19 11:13] – angelegt thasti | projekte:cwloop:start [2022/03/19 11:52] (aktuell) – [Morse Code Callsign Loop] thasti |
---|
====== Morse Code Callsign Loop ====== | ====== Morse Code Callsign Loop ====== |
| |
When establishing RF communications, in particular in a portable setting, an automated CW callsign loop can be a handy capability of any transverter. Since this issue has repeatedly come up, a quick design was whipped up to satisfy this gap. | When establishing RF communications, in particular in a portable setting, an automated CW callsign loop can be a handy capability of any transverter. Since this issue has repeatedly come up, a quick design was whipped up to satisfy this demand. |
| |
{{:projekte:cwloop:onepcb_small.jpg?600|populated circuit board}} | {{:projekte:cwloop:onepcb_small.jpg?600|populated circuit board}} |
| |
{{:projekte:cwloop:panel_small.jpg?600|six populated circuit boards}} | {{:projekte:cwloop:panel_small.jpg?600|six populated circuit boards}} |
| |
| The PCB can be wired as shown below: A front panel toggle switch is used to enable/disable the CW generation, and two audio jacks can be wired to the front panel and the transceiver. This allows using a manual/paddle keyer in addition to this circuit. The PCB simply pulls the "tip" contact to ground to key the TRX. |
| |
| {{:projekte:cwloop:cwloop_wiring.png?600|}} |
| |
| |